and know where the Valet button is located. Be sure to check
with your installer at the time of installation for both the location
and the preset response (1-5 presses) of the Valet button.
(one to five times) within 15 seconds. After five seconds, the system
will disarm. If the system does not disarm, you may have waited too
long; turn the ignition Off and On and try again.
Location of Valet Button_________________________________
Number of Presses_____________________________________
important! The Valet
respond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for
your individual unit.
The remote will indicate disarm notification with 2 beeps and 3
flashes of the Orange LED.
➜
silent mode
To temporarily turn off the vehicle's arm or disarm chirps, use
Silent Mode™. Simply press
arming or disarming, and the confirmation chirp(s) will be elim-
inated for that one operation only. If you want the arm/disarm
chirps turned off permanently, your dealer can do this for you.
© 2005 directed electronics—all rights reser ved
To disarm the security system,
turn the ignition to the ON posi-
tion. Press and release the Valet
button the preset number of times
button can be programmed to
®
DRW-35
for less than 1-second before
21