Positioning - Ariston FK G X Operating Instructions Manual

Installation
! Before operating your new appliance please read
this instruction manual carefully. It contains important
information for safe use, installation and care of the
appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.

Positioning

! Keep packaging material out of the reach of children.
It can become a choking or suffocation hazard (see
Precautions and tips).
! The appliance must be installed by a qualified person
according to the instructions provided. Incorrect
installation may cause harm to people and animals or
may damage property.
! This appliance should only be installed and used
in permanently ventilated rooms in compliance
with current National regulations. The following
requirements must be observed:
• The room must be equipped with an air extraction
system that expels any combustion fumes. This may
consist of a hood or an electric fan that automatically
starts each time the appliance is switched on.
In a chimney stack or branched flue.
(exclusively for cooking appliances)
• The room must also allow proper air circulation, as
air is needed for combustion to occur normally. The
flow of air needed for combustion must not be less
than 2 m /h per kW of installed power.
3
The air circulation system may
take air directly from the outside
by means of a pipe with an
inner cross section of at least
100 cm
A
be vulnerable to any type of
Examples of ventilation holes
for comburant air.
blockages.
Directly to
the Outside
; the opening must not
2
The system can also provide
Adjacent Room to be
Room Vented
the air needed for combustion
indirectly, i.e. from adjacent
rooms fitted with air circulation
tubes as described above.
However, these rooms must not
Enlarging the ventilation slot
be communal rooms, bedrooms
between window and floor.
or rooms that may present a fire
hazard.
• Liquid petroleum gas sinks to the floor as it is
heavier than air. Therefore, rooms containing LPG
cylinders must also be equipped with vents to allow
gas to escape in the event of a leak. As a result
LPG cylinders, whether partially or completely full,
must not be installed or stored in rooms or storage
areas that are below ground level (cellars, etc.). It is
a good idea to keep only the cylinder being used in
the room, positioned so that it is not subject to heat
produced by external sources (ovens, fireplaces,
stoves, etc. ) which could raise the temperature of
the cylinder above 50°C.
Fitting the appliance
Use a suitable kitchen unit to ensure that the appliance
functions properly.
• The panels adjacent to the oven must be made from
heat-resistant material.
• Cabinets with a veneer exterior must be assembled
with a glue that can withstand temperatures of up to
100°C.
• To install the oven under the counter (see diagram)
or in a kitchen unit, the cabinet must have the
following dimensions:
* Stainless steel models only
! The appliance must not come into contact with
electrical parts once it has been installed.
GB
3