Battery - Lexus GS200t 2016 Pre-Delivery Service Manual

INSPECTION DETAILS - A. ENGINE COMPARTMENT
Gasoline vehicles
Hybrid vehicles
BATTERY TERMINAL TIGHTNESS AND
CHARGE
a) Check the electrolyte level. If the electrolyte level is low,
check the battery case for leakage.
b) Check the battery charge. Measure the open-circuit
battery voltage between the terminals. If the voltage
reading is less than 12.6 volts, recharge the battery.
NOTE:
Before measuring the voltage, turn off the engine and all
electrical systems. Wait 60 seconds to remove the surface
charge. If the engine was running before measuring the
voltage, wait 20 minutes after the engine stops to remove
the surface charge.
c) Check that the battery terminals are properly connected
and that the clamp is firmly installed.
1
Terminals
2
Hold-down clamp
d) Print out battery charge test.
WIRING AND HOSES
a) Check the hoses, hose connectors and various clamps
for tightness.
b) Visually inspect the condition of all harness connectors
and terminals for proper installation and tightness.
3 GS200t/350/450h/F