MTD Procut 700 series Operator's Manual page 8

Adjustments
Cutting Height
There is a cutting height adjustment lever
located above the rear right wheel.
1.
Push the height adjustment lever
towards wheel.
2.
Move lever to desired position for a
change in cutting height. See Figure
3-8.
2
Lower
1
Higher
3
Figure 3-8
3. Release lever towards deck.
IMPORTANT: For rough or uneven lawns, move
the height adjustment levers to a higher position.
This will stop scalping or grass.
Set-Up
Gas and Oil Fill-Up
Refer to the separate engine owner's manual for
additional engine information.
1.
Add oil provided before starting unit for
the rst time out of the box.
2. Service the engine with gasoline as
instructed in the separate engine owner's
manual.
WARNING: Use extreme care
when handling gasoline. Gasoline
is extremely ammable and the
vapors are explosive. Never fuel
the machine indoors or while the
engine is hot or running.Extinguish
cigarettes, cigars, pipes and other
sources of ignition.
S 3 — A
8
ECTION SSEMBLY
& S -U
ET P