1. Manuals
  2. Brands
  3. MTD Manuals
  4. Lawn Mower
  5. Pro 560 Series
  6. Operator's manual

MTD 560 Series Operator's Manual

21” three-in-one self-propelled mower
Hide thumbs Also See for 560 Series:
Table of Contents

Advertisement

Quick Links

See also: Operator's Manual
O
M
PERATOR'S
ANUAL
21" Three-in-One
Self-Propelled
Mower
Model
560 Series
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A.
FORM NO. 770-10163B.fm
(3/2002)

Advertisement

Table of Contents
loading

Related Manuals for MTD 560 Series

Summary of Contents for MTD 560 Series

  • Page 1 Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019. MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 PRINTED IN U.S.A.

  • Page 2: Table Of Contents

    A sample model plate is explained below. For future reference, please copy the model number and the serial number of the equipment in the space below. (Model Number) (Serial Number) Copy the model number here: MTD LLC P. O. BOX 361131 Copy the serial number here: CLEVELAND,OH 44136 330-220-4683 www.mtdproducts.com...

  • Page 3: Important Safe Operation Practices

    SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.

  • Page 4: Slope Operation

    20. Never operate mower without proper trail shield, Never allow children under 14 years old to operate a discharge cover, grass catcher, blade control handle or power mower. Children 14 years old and over should other safety protective devices in place and working. read and understand the operation instructions and Never operate mower with damaged safety devices.
  • Page 5 meet the original equipment specifications may lead to expose moving parts or allow objects to be thrown. For improper performance and compromise safety!” safety protection, frequently check components and Mower blades are sharp and can cut. Wrap the blade or replace immediately with original equipment wear gloves, and use extra caution when servicing them.

  • Page 6: Slope Gauge

    SECTION 2: SLOPE GAUGE Use this page as a guide to determine slopes where you may not operate the lawn mower safely.

  • Page 7: Assembling Your Lawn Mower

    SECTION 3: ASSEMBLING YOUR LAWN MOWER To Remove Unit From Carton • Raise the upper handle in the direction shown in Figure 2 (step 3). Tighten the wing nuts which are • Remove staples, break glue on top flaps, or cut tape already on the handle.

  • Page 8: Grass Catcher Assembly

    • With spark plug wire disconnected and grounded, • Secure bag to frame by working the plastic hold the blade control handle against the upper channels on bag over frame as shown in Figure 7B. handle, and pull the starter rope out of the engine. All of the plastic channels except the center top of Release blade control handle.

  • Page 9: Attaching Grass Catcher To Mower

    • Slip the openings in the side of the plastic channel • Place the mounting bracket under the front of the on the bag over hooks on the grass catcher frame. handle, with the tabs on the bracket facing up. See Figure 9B.

  • Page 10: Know Your Lawn Mower

    • Slide the two hooks of the side discharge chute under the hinge pin on the mulching plug assembly Discharge Door as shown in Figure 14. Lower the side mulching plug. • Do not remove the side mulching plug at any time, even when you are not mulching.

  • Page 11: Operating Your Lawn Mower

    Blade Control Handle Lower Bail Handle The lower bail handle is located on the upper handle WARNING: This control mechanism is a and is used to engage the drive. Squeeze the bail safety device. Never attempt to bypass its handle against the upper handle to engage the drive; operations.

  • Page 12: Starting Engine

    Starting Engine • Disconnect the spark plug wire and ground it against the engine to prevent accidental starting For models equipped with Honda engine: while equipment is unattended. • Make sure the fuel valve lever found on the left side Using Your Rotary Mower of the engine is in the ON position.

  • Page 13: Making Adjustments

    SECTION 6: MAKING ADJUSTMENTS Carburetor WARNING: Do not at any time make any adjustment to lawn mower without first WARNING: stopping engine and disconnecting spark plug If any adjustments are made wire. to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts Handle Height and heated surfaces (e.g.

  • Page 14: Maintaining Your Lawn Mower

    SECTION 7: MAINTAINING YOUR LAWN MOWER Replacing Rear Flap Spark plug replacement is recommended at the start of each season. Refer to the engine manual • To remove rear flap, cut off the flat end of the wire for correct spark plug type. rod which secures it to the deck.

  • Page 15: Blade Care

    Wheels • Also lubricate the bolt holes, bolt and the inner surface of the nuts. • The wheels require no lubrication. However, if the • Install the blade adapter on the pulley with the “star” wheels are removed for any reason, lubricate the away from the pulley.

  • Page 16: Off-Season Storage

    Replacing Drive Belt • Push the transmission up a little and slide the belt off the transmission pulley. Loosen this screw • Lift the mower to access the belt from the underside of the mower. Belt • Slide the belt off the engine pulley and around the blade.

  • Page 17: Troubleshooting

    SECTION 9: TROUBLE SHOOTING GUIDE Trouble Possible Cause(s) Corrective Actions Engine fails to Blade control handle disengaged Engage blade control handle. start Spark plug wire disconnected Connect wire to spark plug. Dirty air cleaner Refer to the engine manual. Primer button not depressed Refer to the engine manual.

  • Page 19: An Authorized Service Dealer

    MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC with MTD LLC does not extend any warranty for products respect to new merchandise purchased and used in the sold or exported outside of the United States, its United States, its possessions and territories.

Table of Contents