Figure 14. Configuration Menu Commands - Redundancy On, Backup Unit Not Selected - Comtech EF Data DT-4572 Installation And Operation Manual

DT4572 X-Band Down Converter
System Operation
---------SELECT---------
----CONFIGURATION-MENU--
FREQ= 72XX.XXX-MHz------
ATTN=-10.00-DB---Rx=OFF-
----EXTERNAL-5-MHz------
--REFERENCE-PRESENT-----
--ENTRY-MODE-=-REMOTE---
-COLD-START-=-DISABLED--
FAULT RECOVERY:-MANUAL--
------------------------
REDUNDANCY-CONFIG?-OFF--
------------------------

Figure 14. Configuration Menu Commands - Redundancy ON, Backup Unit Not Selected

ENTER
** Manual when "Redundancy
Config ON" and not in "BU"
* Displayed only when there is
a 5/10 MHz reference input.
ENT + DOWN + ENT
CLR
LEGEND
DISPLAY
---------SELECT---------
--MONITOR-STATUS-MENU---
20
REDUNDANCY-CONFIG?-ON---
-CONVERTER-#-XX---------
KEY-PAD
ENT
CLR
Rev. 0
MM/DT4572.IOM