Fujitsu fi-680PRB Operator's Manual page 18

7
Remove the new print cartridge from its pouch.
8
Remove the protection tape.
Do not touch the metal part of the cartridge nor put
！ ！ ！
the tape back again.
9
Insert the new print cartridge into the print cartridge
holder.
 Insert the print cartridge with the tab on the right
！ ！ ！
side.
 Make sure that the print cartridge does not touch
or get caught in the flat flex cable.
10
Gently close the print cartridge holder cover on the
right side until it is locked, to fix the print cartridge.
11
Align the top of the print position pointer with the
print position mark where printing should be
performed on the document.
(Refer to Step 3 onwards of "Front-Side Imprinter"
(page 14) in "2.3 Positioning the Print Cartridge".)
When setting a print cartridge, align the top of the
！ ！ ！
print position pointer with the print position mark
where printing should be performed on the
document. Otherwise, printing may not be
performed properly, or the document may be
smudged with ink.
12
Close the output feeder unit and then the top cover.
Tab
17
13
Turn on the scanner.
14
Reset the ink level counter as follows.
You must reset the ink level counter whenever you
！ ！ ！
replace the print cartridge.
The ink level counter can be reset from the operator
panel. For details, refer to "3.2 Main Menu" in the
"fi-6400/fi-6800 Image Scanner Operator's Guide".
1 Display the [Software Operation Panel] dialog box.
Windows Server 2008/Windows 7 or earlier
Click [Start] menu → [All Programs] → [fi Series] →
[Software Operation Panel].
Windows Server 2012/Windows 8
Right-click the Start screen, and select [All apps] on
the app bar → [Software Operation Panel] under [fi
Series].
Windows Server 2012 R2/Windows 8.1
Click [↓] on the lower left side of the Start screen →
[Software Operation Panel] under [fi Series].
To display [↓], move the mouse cursor.
Windows 10/Windows Server 2016
Click [Start] menu → [fi Series] → [Software
Operation Panel].
2 Click [Device Setting] from left side list in the window.
3 Click the [Clear] button for [Ink Level: Front].
The value of the [Ink Level: Front] counter is set to
100.
4 Click the [OK] button on the [Software Operation
Panel] window.