Installing / Removing The Base Stand; Installing The Base Stand - JVC LT-42C550 Instruction Manual

Installing / Removing the Base Stand

• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure
that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO
NOT exert pressure on the front of the TV at any time because the screen could crack.
• It is recommended that two people take part in the base installation.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a towel or thick piece of foam) is placed beneath
the screen. Leave the protective bag on your TV until you have fully attached the TV stand.

Installing the Base Stand

1. Fit the stand support onto the stand base. Ensure the stand support marking position is in right position (L = left, R = right).
Align with the screw holes then screw the support by using 4 screws A supplied.
Screw A x 2
2. Rotate the stand assembly so the metal bar face to the front of the TV. Insert the stand support under the bottom of the TV.
The stand assembly will fit snugly into the TV. Then screw the stand to the TV by using 4 screws B supplied.
180°
TV Stand
Base Front
TV Stand
(metal bar)
Support
(Right)
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance:
For UK, please call our UK Call Centre on 0344 561 1234.
For Ireland, please call our Ireland Call Center on 1 890 818 575.
TV Stand Support
(Left) (included)
TV Stand Base Front
(included)
TV Stand
Support
(Left)
TV Stand Support
(Right) (included)
screw B x 4
Preparation
Screw A x 2
Table
Cushioned
Material
Protective
Bag
2
9