Table of Contents
Advertisement
Original instructions
1
Description ............................................................................................................ 2
2
Technical data ....................................................................................................... 2
3
Technical data sheet ............................................................................................. 4
4
Plates ..................................................................................................................... 4
4.1 Plates on HACRP8 unit in a radio remote control ............................................. 4
4.2 Plates on HACRP8 unit in a Take & Release radio remote control ................... 4
5
Warnings for installation ...................................................................................... 5
5.1 Mounting and fastening the receiving unit in the best position .......................... 5
5.2 Positioning the antenna ................................................................................... 6
5.3 Wiring .............................................................................................................. 6
6
Light signals .......................................................................................................... 6
7
Operation ............................................................................................................... 7
7.1 Electronic module ............................................................................................ 7
7.2 DIP switches .................................................................................................... 7
7.3 Command outputs ............................................................................................ 7
8
Malfunction signalled by the receiving unit ........................................................ 7
AUTEC
Air series
Part D: receiving unit
HACrP8 (rPD)
inDex
LIRPDE00-03
Advertisement
Table of Contents
Related Manuals for AUTEC HACRP8
Summary of Contents for AUTEC HACRP8
-
Page 1: Table Of Contents
4.1 Plates on HACRP8 unit in a radio remote control ..........4 4.2 Plates on HACRP8 unit in a Take & Release radio remote control ....4 4.3 Plates on HACRP8 unit in a Multi Units or Multi Receiver radio remote control 5 Warnings for installation ..................5 5.1 Mounting and fastening the receiving unit in the best position ...... -
Page 2: Description
STOP contacts rated current ................4A (250V ) STOP contacts protection fuse ............4A T 250V (5x20mm) Commands rated current ................4A (250V ) Housing material ..................PA 6 (20%fg) Protection degree ..................IP65 (NEMA 4) Weight ....................... 0.65kg (1.43Lb) LIRPDE00-03 AUTEC - Air series... - Page 3 - Before switching on please read the user manual. - Adhere to safety rules. - Disconnect power source and wait 10 seconds before opening. - Prima dell'accensione leggere il manuale d’uso. - Attenersi alle norme di sicurezza. - Togliere l’alimentazione e attendere 10 secondi in caso di apertura. AUTEC - Air series LIRPDE00-03...
-
Page 4: Technical Data Sheet
On the cover of the technical data plate technical data, marking and possible receiving unit. radio remote control marks. Plates on HACrP8 unit in a Take & release radio remote control Plate Position Content radio remote control On the cover of the... -
Page 5: Plates On Hacrp8 Unit In A Multi Units Or Multi Receiver Radio Remote Control
Warnings for installation Plates on HACrP8 unit in a Multi Units or Multi receiver radio remote control Plate Position Content Radio remote control serial number radio remote control On the cover of each (MULTI S/N), bar code and identification plate receiving unit. -
Page 6: Positioning The Antenna
Positioning the antenna The following warnings complete and/or replace the corresponding information in the paragraph about part A. The HACrP8 receiving unit is not set up for the use of an antenna extension kit. Wiring The following warnings complete and/or replace the corresponding information in the paragraph about part A. -
Page 7: Operation
The receiving unit does The red indicator light activate the corresponding relays. not activate the outputs of blinks fast the commands sent. Check the protection fuse of the STOP contacts and, if needed, replace it. AUTEC - Air series LIRPDE00-03...