Setting The Alarm - Blaupunkt BR-50DAB Instruction Manual

BASIC OPERATION (CONT.)

Setting the Alarm

Note: Check that the radio has the correct time and date before you set an alarm.
With your radio switched on (not in Standby mode):
1. Press and release the Alarm button.
2. Alarm 1 Setup is displayed.
Note: Press and release the Alarm button again to switch to Alarm 2 Setup.
3. Press and release the Select button.
4. Alarm 1 (or 2) Wizard On time is displayed and the hour digits for the alarm will flash.
5. Press and release the Prev or Next buttons to scroll to the hour for the alarm and
press and release the Select button
6. The minutes will now flash. Press and release the Prev or Next buttons to scroll to
the minutes for the alarm and press and release the Select button.
7. The duration time will now flash. Press and release the Prev or Next buttons to
scroll to the duration for the alarm. You can choose from 15, 30, 45, 60, 90 and
120 minutes. Press and release the Select button.
8. The source for the alarm will now flash. Press and release the Prev or Next buttons
scroll to the sound source for the alarm. You can choose from Buzzer, DAB or FM.
Press and release the Select button.
Note: If you select DAB or FM radio for the alarm source, 'Last listened' will flash in the
display. Press the Select button and the last listened to radio station in DAB or FM, as
appropriate, will be used for your alarm.
9. Press and release the Prev or Next buttons to scroll to the frequency for the alarm.
You can choose from Daily, Once, Weekends or Weekdays. Press and release the
Select button.
Note: If you select 'Once', you will then be prompted to set the date for your alarm.
10. Press and release the Prev or Next buttons to set the volume for your alarm.
Press and release the Select button.
Note: Remember to set the alarm radio volume to one that will wake you. The alarm
volume will increase progressively until it reaches the alarm volume you have set.
11. Alarm 1 Wizard is displayed again, together with Alarm Off (or On).
Press and release the Prev or Next buttons to choose Alarm On of Off press and
release the Select button to confirm. Alarm saved is displayed.
12. A bell symbol in the display, together with the digit '1' or '2' as appropriate, will
confirm that an alarm has been set.
Note: If the time is not set or has failed to update from the radio signal, Time is not set
will be displayed when you try to set the alarm. The radio will then prompt you to set
the time. An alarm can only be set after the time has been set.
19