EdgeStar AP12000HS Owner's Manual page 14

Dehumidifying Mode:
During the Dehumidifying mode, the unit will condense water out of the air and exhaust it
through the exhaust hose. The ambient temperature in the room will probably drop by a few
degrees while using the Dehumidifying mode.
To operate the unit in dehumidifying mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button.
3. Press the Mode button until the LED indicator next to "Dehumidify" lights up.
Notes: If the room temperature is below 77° F, the fan will always run on low speed while in the
Dehumidifying mode. If you do not use the exhaust hose in Dehumidifying mode, you must
manually drain the water from the unit. Additionally, the ambient temperature in the room will
probably rise by a few degrees if you do not use the exhaust hose. You will not be able to change
the thermostat temperature while in Dehumidifying Mode.
Heat Mode:
Your air conditioner can work as a heat pump. It must be vented so that it can expel the cold
air out of the exhaust.
To operate the unit in heat mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button.
3. Press the Mode button until the LED indicator next to "Fan" lights up red.
Fan Only Mode
Fan Only mode is used to circulate the air in your room. No temperature setting is needed.
To operate the unit in Fan Only mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button.
3. Press the Mode button until the LED indicator next to "Fan Only" lights up.
4. Press the Speed button to select the fan speed. You can choose between High, Medium,
and Low. The LED indicator next to the speed will light up.
Note: Fan Only mode does not require that the exhaust hose be attached.
Speed
The Speed button is used to change the fan speed while in Cooling and Fan Only modes.
Press the Speed button to select the fan speed. The LED indicator light next to the High,
Medium, or Low settings will light up.
10