Table of Contents
Advertisement
Burn, Electrlcal
Shock and Fire Hazard
l
Make
sure all surface
units are OFF betore
replaclng
surface
units and
reflector
bowls. Fallure to do so can result In burns or electrical
shock.
l
Do not llne the reflector
bowls wlth foil. Flre or electrlcal
shock
could
result.
1.
Turn off all surface units.
2. Line up openings
in the reflector
bowl and notch in the trim ring
with the surface unit receptacle
and the element
hold down clip.
3. Hold the surface
unit as level as
possible
with the terminal
just
started
into the receptacle.
Push
the surface
unit terminal
into the
receptacle.
4. When terminal
is pushed
into the
receptacle
as far as it will go, push
down the edge
of the surface
unit
opposite
the receptacle.
The ele-
ment hold down clip will keep the
surface unit from moving
around.
NOTE: Reflector
bowls reflect
heat back
to the utensils
on the surface
unlts. They also help catch
spills. When they are kept clean,
they reflect
heat better
and look new longer.
If a trlm rlng gets discolored,
some of the utensils
may not be flat enough,
or some may be too large for fhe surface
unit. In elther
case, some of
the heat that's meant
to go into or around
a utensil goes down and heats
the trlm rlng. lhls extra heat can discolor
it. See Cooking
Guide
for further
Informatlon.
Advertisement
Table of Contents
