Operating Instructions; Spa Controls - 120V Models - Legacy Whirlpool LW 524 Owner's Manual

Spa Controls - 120V Models

INITIAL START-UP
When your spa is first turned on, it will go into Priming mode, indicated by "Pr " The Priming
mode will last for less than 5 minutes (press Warm or Cool to skip Priming Mode) and then the spa
will begin to heat and maintain the water temperature in the Standard mode.
TEMP (80°F - 104°F / 26°C - 40°C)
The start up temperature is set at 100F° (37°C). The last measured temperature is constantly dis-
played on the LCD.
Note that the last measured spa temperature displayed is current only when the low speed of
Pump 1 has been running for at least 2 minutes.
To display the set temperature, press the Warm or Cool button.
Temperature setting is accomplished by pressing Warm repeatedly to increase the temperature or
Cool repeatedly to decrease the temperature.
After three seconds, the LCD will stop flashing and display the current spa temperature.
JETS
Press the Jets button to turn Pump 1 on, shift between low and high speed (if applicable) and
to turn it off. If left running, the pump will turn off after a time-out period (15 minutes for high
speed pumps).
LIGHT
Press the Light button to turn the light on and off. If left on, the light automatically turns off after
4 hours.
LED LIGHT (IF EQUIPPED)
Press the Light button to turn the LED lighting on and off. Most LED lighting will offer multiple
color modes. If you wish to change the color mode of the LED lighting, turn the lights off and then
on, within 5 seconds.
DO NOT DIVE. 100
DO NOT DIVE. 44