Replacing The Rf Antenna - Ryobi GD125 Operator's Manual

REPLACING THE RF ANTENNA

See Figure 95.
 Lower the power head and disconnect the rail assembly.
 Remove the light cover.
 Disconnect the LED board and button board wires from
the circuit board.
 Set the light cover aside.
 Place the power head on a flat surface with the top of the
motor facing up.
 Remove the old RF antenna from the circuit board and
pull it away from the power head.
 Connect the new RF antenna to the ant connection on
the circuit board, refer to schematic.
 Insert the loose end of the RF antenna through the hole
in the power head.
 Gently pull on the loose end until most of the RF antenna
is on the exterior of the power head.
 Connect the LED board wire to the LED board connection
on the circuit board, refer to schematic.
 Connect the button board wire to the key board
connection on the circuit board, refer to schematic.
 Attach the light cover to the power head.
 Raise and mount the power head as described earlier.
MAINTENANCE
52 - English
Hole
RF
Antenna
Fig. 95