Installation Verification Checklist - Ryobi GD125 Operator's Manual

Upon completion of installation and setup of your garage door opener and controls, perform all of the items on the following
checklist to ensure the garage door opener functions properly:
WARNING:
Failure to complete the Installation Verification Checklist and verify proper function of the garage door opener can result
in death or serious personal injury.

INSTALLATION VERIFICATION CHECKLIST

Use the indoor keypad to open and close the garage door. Ensure garage door moves smoothly from
fully open to fully closed and from fully closed to fully open.
With the garage door raised, place a 1-1/2 in. Board (approximately the size of a 2x4 laid flat) on the garage
floor beneath the door and attempt to close the door on the object. Ensure the garage door automatically
reverses direction upon contacting the object.
With the garage door raised, press the UP/DOWN button on the indoor keypad to close the door. Pass
an object, such as a broomstick, between the safety sensors to break the safety beam while the door is
lowering. Ensure the garage door automatically raises when the beam is broken.
With the garage door lowered, pull the safety handle to disengage the door from the drive unit. Ensure
the door is free to move once the outer trolley disengages from the inner trolley. Once this is confirmed,
use the indoor keypad to cycle the drive unit and reengage the door to the drive unit.
If the garage door opener has been connected to the RYOBI Garage Door Opener Accessory System
app feature, test this feature prior to use. With the garage door raised, attempt to lower the door using
the smartphone app. Ensure that the garage door opener light flashes and a beeping sound is emitted
for a few seconds prior to the door beginning to lower.
If any one of the above items fails to function as described in this Operator's Manual, do not use the garage door opener
and contact customer service or a qualified service person for assistance.
INSTALLATION
40 - English
