Hitachi CG 25SC Service Manual page 8

(3) Remove the eight Screws ST4 x 16 <1> from Housing (R) <43> and Housing (L) <41>. Detach the
Motor <37> with the Wire Roll Support <49>, Button <34>, Lock Pin <35>, and Spring (C) <36> as
shown in Fig. 11.
(4) Remove the two Screws ST3 x 6 <32> from the Pipe Ass'y <22> to remove the Spacer <31> as shown
in Fig. 11.
Fig. 11
<1>
2. Removing the motor
(1) Use a hex. bar wrench to turn the Cap <53>
inside the Wire Roll Support <49>. The Cap
<53> comes off together with the M5 Nut <52>.
(2) The Wire Roll Support <49> is press-fitted to the
Motor <37>. Use a large bearing puller to
remove it. For easy removal of the support, use
the two side holes of the Wire Roll Support
<49> and the end of the Motor <37> shaft. The
Wire Roll Support <49> is in contact with the
ball bearing of the Motor <37> as shown in Fig.
12.
<43>
<31>
<34>
<36>
<35>
<37>
<38>
-7-
<22>
<32>
<11>
<12>
<39>
Fig. 12
<41>
<37>
<38>
<49>
<52>
<53>