Hitachi CG 25SC Service Manual page 3

(3) Remove the eight Screws ST4 x 16 [4] from Housing (R) [29] and Housing (L) [35]. Detach the Motor
[39] with the Wire Roll Support [41], Button [32], Lock Pin [33], and Spring (C) [34] as shown in Fig. 3.
(4) Remove the two Screws ST3 x 6 [30] from the Pipe Ass'y [24] to remove the Spacer [31] as shown in
Fig. 3.
Fig. 3
[24]
[29]
[4]
2. Removing the motor
(1) Use a hex. bar wrench to turn the Cap [45]
inside the Wire Roll Support [41]. The Cap [45]
comes off together with the M5 Nut [44].
(2) The Wire Roll Support [41] is press-fitted to the
Motor [39]. Use a large bearing puller to remove
it. For easy removal of the support, use the two
side holes of the Wire Roll Support [41] and the
end of the Motor [39] shaft. The Wire Roll
Support [41] is in contact with the ball bearing
of the Motor [39] as shown in Fig. 4.
[33]
[32]
[30]
[31]
-2-
[11]
[10]
[34]
[38]
[39]
Fig. 4
[35]
[39]
[40]
[41]
[44]
[45]