Hitachi CG 25SC Service Manual page 10

Reassembly of the Model CG 30SC
Reverse the disassembly procedure to reassemble the Model CG 30SC. However, pay particular attention
to the following.
1. Notices on reassembly
(1) Press-fit the Wire Roll Support <49> to the Motor <37> until
the Wire Roll Support <49> contacts the ball bearing of the
Motor <37>.
NOTE: Do not press-fit with excessive force. Otherwise,
the Wire Roll Support <49> may be broken.
After press-fitting, put the Cap <53> on the M5 Nut <52> and
tighten it to the shaft of the Motor <37>.
NOTE: Do not press-fit with excessive force. Otherwise,
the Cap <53> may fall off.
NOTE: The wire roll support of the Model CG 30SC is
similar to that of the Model CG 25SC but they are
not interchangeable (5-mm portion is slightly
different in shape.) Do not mismount.
NOTE: Replace the Wire Roll Support <49> with new one
without fail when replacing the Motor <37>.
(2) Mount the Lock Off Button <4> and Spring (B) <3> into Handle (L) <13>, and then put Handle (L) <13>
and Handle (R) <2> together aligning the position of Spring (B) <3>.
NOTE: When putting Handle (R) <2> and Handle (L) <13> together, completely fit the internal
wires into the grooves of the handle ribs so that the internal wires are not pinched by
the handle bodies.
NOTE: The position of the Lock Off Button <4> is predetermined. Fit the protrusion of the Lock
Off Button <4> in the recessed portion of Handle (L) <13>.
Fig. 15
<3>
<13>
<16>
<4>
<20>
<5>
<6>
Fig. 14
<7>
<11>
<12>
<14>
<15>
-9-
<37>
<38>
<49>
<52>
<53>
<22>