Toro TimeCutter SW 4200 Operator's Manual page 12

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in those conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the Operator's Manual.
2. Cutting hazard of hand, mower blade;
pinching hazard of hand, belt—keep
hands and feet away from moving
parts; keep all guards and shields in
place.
132-0870
3. Bodily harm hazard—no riders; look
behind you when mowing in reverse.
4. Thrown object hazard—keep
bystanders away from the machine;
remove debris from the area before
mowing; keep the deflector shield
down.
12
5. Ramp tipping hazard—when loading
onto a trailer, do not use dual ramps;
only use a single ramp wide enough
for the machine and that has an incline
less than 15 degrees; back up the
ramp (in reverse) and drive forward off
the ramp.
6. Tipping hazard on slopes—do not
make sharp, quick turns; do not use
slopes greater than 15 degrees.
decal132-0870