Table of Contents
Advertisement
A0h
A2h
A3h
E4h
E5h
E7h
F7h
F8h
FBh
© GEMPLUS
APPENDIX D - STATUS CODES
Card malfunction; the TA1 byte of an asynchronous
card Answer To Reset is incorrect. The Smartcard
protocol is not accepted.
Card malfunction. The card is not responding to
reset or has interrupted an exchange (by time-out).
Parity error (in the course of an exchange between
the asynchronous card and the reader). The error
only occurs after several unsuccessful attempts at
retransmission.
The card has just sent the reader an invalid
"Procedure Byte" (see ISO 7816-3).
A command was issued, but no data was
exchanged.
The SW1 and SW2 bytes returned by the card are
not 90 00h.
Card removed; the card has been withdrawn while
carrying out of an instruction. Make sure that the
card instruction is complete.
Card in short circuit.
Card absent. There is no card in the connector. The
card may have been removed when powered on, but
no instruction has been interrupted.
31
Advertisement
Table of Contents
