Advertisement
FCC ID: QN3WD01
ION Digital LLP
Preparation
1.
Determine a suitable location for the sensor and the magnet. These units are meant to be mounted
inside the frame of the window. As such do not drill a mounting hole unless:
•
You are a qualified installer
•
There is sufficient room for the devices in the frame and window (Not all windows may have the
necessary clearance).
•
You have read, and are familiar with the mounting instructions for the sensor and magnet
(specifically the orientation required – see diagram included)
•
You have the custom drill bit to allow proper mounting of the sensor and magnet in the frame.
2.
Measure and mark where the sensor and magnet will be installed in the window frame. Use the guide
provided in Fig 2 for the location of the two holes. The magnet and the sensor need to be offset for
correct performance.
3.
Always ensure that the magnet is mounted on the side that the opening will occur on. Do not mount
the magnet such that it has to travel over the sensor before it moves away from the sensor (Fig. 3).
4.
Measure the distance between the window panel and frame. Ensure the separation is no more than
0.75" in height. Note: In cases where the separation may be greater, a larger magnet may be required.
Contact the manufacturer for alternate magnets.
5.
Verify the sensor will operate properly with the control panel, prior to drilling any holes.
Fig 2. Correct Positioning the Magnet and the Sensor relative to each other
Magnet in Window Panel
Direction of Window
Movement, away from
sensor
Direction of Window Movement,
away from sensor.
Left, Up, or Out of Page
ION Digital LLP
P.O. Box 3969 Blaine Washington
USA 98231
Sensor in Frame
0.95"+/-0.10"
2 of 6
Installation Guide
11/04/02
Ph#
1-800-407-4389
Fax# 1-800-407-4465
www.ion-digital.com
Advertisement
