Advertisement
FCC ID: QN3WD01
ION Digital LLP
Entering and Testing Sensors
The sensors need to be entered into the control panel memory. This is done by entering the 6 digit
(including HEX values) ESN into the panel to record it. Refer to your panel installation manual for
complete details.
To test the sensor, you need to enter the panel's wireless test mode. Then:
1.
Trip the sensor. This is done by moving the magnet in, and out of position.
2.
Verify the panel was able to read the sensor.
3.
Repeat this with all the sensor's being installed.
Fig 4. Dowel Package, Dowel Lid, Sensor Electronics (including battery)
Fig. 5: Assembled Sensor
ION Digital LLP
P.O. Box 3969 Blaine Washington
USA 98231
4 of 6
Installation Guide
11/04/02
Ph#
1-800-407-4389
Fax# 1-800-407-4465
www.ion-digital.com
Advertisement
