Advertisement
FCC ID: QN3WD01
ION Digital LLP
Installation in Window Frame
1.
Using the dealer provided window frame bit supplied with your dealer kit, drill a ¾" hole in the frame
for the sensor, and one in the window panel for the magnet.
2.
Both the sensor and the magnet have ribs on the outside that will provide a bite fit into the frame. First
insert the wire into the inside of the frame, through the hole just drilled. Slowly press the sensor into
the window frame until it's lid is flush with the frame base.
3.
IMPORTANT !!! Ensure the Sensor is lined up in the window frame such that the ION Logo is
pointing out the window. This is required to line the magnet and the sensing device properly.
4.
The dealer has the option of using a sealing agent at this point if weather proofing is required. Note
that if a sealant is used, it will have to be redone at some point in the future when the device's battery
is replaced (typically every 10 years).
Replacing the Battery
The sensor requires a Lithium coin cell battery to operate. The type required for this sensor is a CR1632
battery. The battery holder is marked with positive "+" and negative "-" notation on the side of the clip.,
and the battery is also marked accordingly. Ensure the battery is replaced in the correct orientation.
The battery lifetime is affected by various factors, including temperature, frequency of window openings,
and unit to unit variations. For a replacement battery, contact ION Digital.
Specifications
Dimensions:
Power Source:
Transmit Range:
Compatibility:
Temperature Range:
ION Digital LLP
P.O. Box 3969 Blaine Washington
USA 98231
Dowel Package Lid
Dowel Package
Wire Antenna
5 of 6
0.850" diameter x 0.030" thick
0.750" diameter
Approx. 9" x 0.050" diameter.
3.0V Lithium Coin Cell Battery
CR1632
Typically >500 ft, open air
433.92 MHz ION Digital Wireless Receiver Panels
10° to 120° F (-12° to 49° C)
Installation Guide
11/04/02
Ph#
1-800-407-4389
Fax# 1-800-407-4465
www.ion-digital.com
Advertisement
