Maintenance And Cleaning - Beko BKS 9218 User Manual

4

Maintenance and Cleaning

To empty the water inside the container, switch
•
off the appliance by pushing on the On/Off
switch and disconnect the power supply cable
from the mains.
Remove the motor unit after unlocking the
•
container locking/unlocking parts on each side
of the container.
Remove the water separator and the air
•
distributing part.
Empty the water inside the container by tilting it
•
towards the opposite side of the inlet socket. You
can use the handle of the container.
It is strongly recommended to dump the water
•
inside the container and to wash out any dirt
that might be remaining inside the container
after each use.
It is recommended to wipe inside the container
•
with a dry cloth after washed.
You may wash the HEPA filter under the water.
•
It is recommended that the vacuum cleaner is
•
stored without water inside the container. It is
best to fill the filtration water (1 ,5 1) right before
the use.
WARNINGS: Please make sure
A
that the air distributing part and
water separator parts are always in
place when the vacuum cleaner is
operated.
Vacuum Cleaner With Water Filtration / User Manual
If the vacuum cleaner overturns accidentally
during operation, switch the unit off and unplug
immediately. Dump the water inside the container
and follow the cleaning procedure described
in "Maintenance and Cleaning the Appliance»
section, above. Make sure that all the parts have
been dried before using the appliance again.
9 / 9 EN