Place The Maestro On The Work Surface Offset; Installing The Maestro Fixed Angle Stand Assembly; Locating The Fixed Angle Stand Mounting Screw Holes - FlexRadio Systems Maestro Installation Manual

Place the Maestro on the Work Surface Offset

As shown in the picture below, place the Maestro touch screen display face down on the top of the foam
packing material allow the knobs to rest on the covered work surface. This will allow of the Maestro to lie
flat for the installation of the Fixed Angle Stand.

Installing the Maestro Fixed Angle Stand Assembly

Once the Maestro is properly oriented, the Fixed Angle Stand can be conveniently installed.

Locating the Fixed Angle Stand Mounting Screw Holes

Locate the three (3) M4 mounting screw holes at the bottom center of the Maestro as shown below with
the three arrows.
Page 4 © 2016 FlexRadio Systems, v1.0.0