Yanmar 3TNV82A Service Manual page 235

Fuel Injection Pump
10. Remove the fuel supply line (Figure 7-6, (4)).
Plug the open end of the line to minimize
leakage and prevent contamination.
11. Remove the throttle cable from the fuel injection
pump.
12. Separate the stop solenoid wiring connector
(Figure 7-7, (2)).
13. Remove the rear fuel injection pump bracket(s)
(Figure 7-7, (1)) from the fuel injection pump.
Note: Configuration of the fuel injection pump
rear brackets may vary depending upon
engine model.
(1)
(2)
Figure 7-7
14. Disconnect the lube oil line (Figure 7-8, (1))
and the clamp (Figure 7-8, (2)) from the pump.
IMPORTANT
Take care to not damage or bend the oil
line. In some applications, it may be
preferable to remove the complete oil line
assembly from the engine before
proceeding.
Note: On models 3TNV82-4TNV88, the fuel
injection pump drive gear cover is
retained to the gear case cover by 4
bolts. On models 4TNV94-4TNV106, the
cover is larger and retained by 7 bolts.
TNV DI Service Manual
15. Remove the fuel injection pump drive gear
cover (Figure 7-9, (1)) from the gear case
cover (Figure 7-9, (2)).
Note: The fuel injection pump drive gear cover
is secured with an adhesive sealant. Use
a gasket scraper to separate the fuel
injection pump cover from the gear case
cover.
0000153A
Note: TNV82-88 shown.
FUEL SYSTEM
(2)
Figure 7-8
(1)
Figure 7-9
(1)
0000593B
(2)
0002039
7-17