•
System status (link status, rates, statistics counters)
•
Temperatures, voltage reports and alarms.
Overheating Detection, Warning and Safeguard
The ALM LED turns on when the line card's internal temperature is too high and turns off when the temperature
has returned to a normal level.
1.4 Default Settings
This section lists the default configuration of the ALC1224.
1.4.1
Default ADSL Settings
The following are general default settings of the ADSL ports.
•
Enable/Disable State: Disabled
•
Operational Mode: auto
1.4.2
Default Profile Settings
The following are the settings of the default profile.
•
Name: DEFVAL
•
Profile Status: Active
•
Latency Mode: Interleave
Downstream ADSL settings:
•
Target Signal/Noise Ratio: 6 db
•
Maximum Signal/Noise Ratio: 31 db
•
Minimum Signal/Noise Ratio: 0 db
•
Minimum Transmission Rate: 32 Kbps
•
Maximum Transmission Rate: 2048 Kbps
•
Latency Delay: 4 ms
Upstream ADSL settings:
•
Target Signal/Noise Ratio: 6 db
•
Maximum Signal/Noise Ratio: 31 db
•
Minimum Signal/Noise Ratio: 0 db
•
Minimum Transmission Rate: 32 Kbps
•
Maximum Transmission Rate: 512 Kbps
ALC1224 Overview
ALC1224 User's Guide
1-3