Advertisement
PA168V MGCP FXS Gateway Telnet Setup Guide (V1.49)
When PA168V MGCP FXS gateway is properly installed, you can set each
parameter through PC and Telnet commands.
Details please refer to《PA168V MGCP FXS gateway Spec and Install》
Telnet Configuration
● On the PC choose Start>Run, type telnet 192.168.1.100 into Run field
in popuping Run dialog. Or input telnet 192.168.1.100 in the DOS
window. Then the following information will be displayed.
PA168X V1.49 settings
Password :
Then please type password. With debug set as 0[disable], if you type ordinary
password (default one is 1234), after Retun, you will see：
Password : ****
P:\>
If you type super password, then you will see:
Password : ********
P:\>
The above information indicates that PA168V FXS gateway is under setting
mode, and then you can set the PA168V FXS gateway by using the telnet
commands.
PA168V Telnet Commands Explanation
Command
Function
2
Advertisement
