Display Bezel - Dell Latitude 5290 Owner's Manual

4 Place the computer on the edge of a plane surface with the display facing down.
5 To remove the display assembly:
a Remove the 4 (M2*5) screws that secure the display assembly to the system [1].
b Lift the display assembly away from the system [2].
Installing display assembly
1 Place the chassis on the edge of a plane surface.
2 Align the display assembly to align with the screw holders on the system.
3 Replace the 4 (M2*5) screws to secure the display assembly to the system.
4 Lift the computer and close the display.
5 Connect the display cable to the connector on the system board.
6 Place the metal bracket to secure the display cable.
7 Replace the single M2*5 screw to secure the metal bracket to the system.
8 Route the WLAN and WWAN cables through the routing channels.
9 Install the:
a WWAN card (optional)
b WLAN card
c hinge cover
d battery
e base cover
10 Follow the procedure in

Display bezel

Removing display bezel - non-touch
1 Follow the procedure in
2 Remove the:
36 Removing and installing components
After working inside your computer.
Before working inside your computer.