Table of Contents
Related Manuals for Siterwell GS816B
Summary of Contents for Siterwell GS816B
- Page 1 Instruction Manual CARBON MONOXIDE ALARM Thank you for your support Please read the instruction manual carefully before operating Please keep the instruction manual for future reference SITERWELL ELECTRONICS CO.,LIMITED 1 / 8...
-
Page 2: Product Introduction
Product Introduction Thank you for purchasing the GS816B wireless carbon monoxide (CO) alarm. This device is a product that has been built using state-of- the-art technology. This detector is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network and it’s security framework. - Page 3 For “Inclusion” in (adding to) a network: a: Put the Z-Wave interface controller into “include” mode, and following its instruction to add the GS816B to your controller. To get in the “inclusion” mode, the position of the detector and controller should be kept in the usual working position.
-
Page 4: Installation Instructions
always on about 5 seconds, else the yellow led always on 5 seconds. Note: Exclusion network status, you can click on the button to exit. Note: If the alarm is remove(excluded), then the sensor will be itself restored to factory default settings. 4: Factory Default Reset It happens automatically when the device is excluded or you can use the following steps to reset factory settings. - Page 5 As you install the battery on the unit, maybe it will sound for several minutes, then stop and enter in normal operation mode. If it always sounds, please call our agent. 3: Recommended installation locations: The following suggestions are intended to help you with the placement and installation of your CO alarm. ...
- Page 6 NOTE: The unit will not protect against the risk of carbon monoxide poisoning when the battery has drained. 5: End of life warning If the unit chirps 3 times every 30 seconds with FAULT indicator (yellow LED and beep) flash. It indicates end of life of CO alarm. You need to immediately replace the CO alarm.
-
Page 7: General Maintenance
be identified and corrected. Unless the reason for the alarm is obviously spurious, do not use the fuel-burning appliances again, until they have been checked and cleared for use by a competent person according to national regulations. General maintenance To keep your CO alarm in good working order, please follow these simple steps: 1: Verify the unit's alarm sound and indicators operation by enable the TEST&SILENCE button once a week. - Page 8 WARNING : The apparatus may not prevent the chronic effects of carbon monoxide exposure, and that the apparatus will not fully safeguard individuals at special risk. Manufacturer and Service information SITERWELL ELECTRONICS CO.,LIMITED ADDRESS: NO.76 HAICHUAN ROAD, CHUANGYE ZONE B, JIANGBEI, NINGBO, CHINA TEL: 0086-0574-87729581 FAX: 0086-0574-87729581 Sales@china-siter.
Need help?
Do you have a question about the GS816B and is the answer not in the manual?
Questions and answers