Module Programming Procedure - FlashLogic FLC-AL(DL)-CH4-EN Install Manual

ADS-AL(DL)-CH4 1-2 XX-XX
inStall GUide
ADS-AL(DL)-CH4 90
Page 8 of 11
1
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
1
2
3
4
5
www.flaShloGic.com
inStaLLatiOn mOde SeLeCtiOn
Press and release
programming button
to select installation mode.

mOdULe PrOgramming PrOCedUre

Close driver door.
Re-open driver door to wake up
data bus.
Insert key into ignition.
Turn key to ON position.
ON
LED will turn solid RED.
Within 5 seconds, LED will fl ash
GREEN rapidly.
U.S. Patent No. 8,856,780
FLC-AL(DL)-CH4-EN
2
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
6
7
8
UNLOCK
9
10
ALL IN ONE
Chrysler/DoDge/Jeep
Doc. No.: ##23962##
Press and hold
programming button
until LED turns solid GREEN
to register selection.
Turn key to OFF position.
OFF
Remove key.
Press UNLOCK on the OEM
remote.
If vehicle is not equipped with
OEM remote, press module
programming button.
Wait, LED will turn solid GREEN
for 2 seconds.
Module Programming
Procedure completed.
automotive data Solutions inc. © 2015
PAGE X-X PAGE X-X
20151028