Table of Contents
Advertisement
• Make sure you position the pan supports cor-
rectly after cleaning.
• To make the burners work correctly, make
sure that the arms of the pan supports are in
the centre of the burner.
• Be very careful when you replace the
pan supports to prevent the hob top
from damage.
After cleaning, dry the appliance with a soft
cloth.
Removing the dirt:
1. – Remove immediately: melting plastic,
plastic foil, and food containing sugar.
– Stop the appliance and let it cool
down before you clean: limescale rings,
water rings, fat stains, shiny metallic dis-
colorations. Use a special cleaner appli-
cable for surface of hob.
2. Clean the appliance with a damp cloth and
some detergent.
3. At the end rub the appliance dry with a
clean cloth.
Troubleshooting
Problem
There is no spark when lighting the
gas
The flame is blow out immediately
after ignition
The gas ring burns unevenly
If there is a fault, first try to find a solution to the
problem yourself. If you cannot find a solution to
the problem yourself, speak your dealer or the
local Service Force Centre.
8
the glass or between the rims of the burners
and the frame (if applicable).
Also, do not let hard or sharp objects fall onto
the glass or hit the edge of the hob.
during the cooking.
Cleaning of the spark plug
This feature is obtained through a ceramic igni-
tion candle with a metal electrode. Keep these
components well clean to prevent difficult light-
ing and check that the burner crown holes are
not obstructed.
Periodic maintenance
Periodically speak your local Service Force
Centre to check the conditions of the gas sup-
ply pipe and the pressure adjuster, if fitted.
Possible cause
• There is no electrical supply
• Burner cap and crown are
placed uneven
• Thermocouple is not heated suf-
ficient
• Burner crown is blocked with
food residues
registered engineer, the visit from the customer
Warning! Do not use knives, scrapers or
similar instruments to clean the surface of
Warning! Do not slide cookware over the
glass because it could scratch the surface.
Warning! Do not put the aluminium foil on
the hob top to keep the surface clean
• Make sure that the unit is con-
nected and the electrical supply
is switched on.
• Control the fuse. If the fuse is
released more than one time, re-
fer to a qualified electrician.
• Make sure that the burner cap
and crown are in correct posi-
tions.
• After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
• Make sure that the injector is
not blocked and the burner
crown is clear of food particles.
If you operated the appliance incorrectly, or
the installation was not carried out by a
Remedy
www.zanussi.com
Advertisement
Table of Contents
