Table of Contents
Advertisement
Control knobs
Symbol
Daily use
Warning! Refer to the Safety chapters.
Ignition of the burner
Warning! Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any responsibility in case
of misuse of the flame
Always light the burner before you put
cookware.
Lightning the burner:
1. Push the control knob down and turn it
counterclockwise to the maximum position (
).
2. Push the control knob and hold it for equal
or less than 10 seconds. This lets the ther-
mocouple to warm up. If not, the gas supply
will be interrupted.
3. Adjust the flame after it is regular.
If the burner does not light after some tries,
check if the crown and its cap are in cor-
rect positions.
6
Description
no gas supply / off posi-
tion
Symbol
A) Burner cap and crown
B) Thermocouple
C) Ignition candle
Warning! Do not keep the control knob
pushed for more than 15 seconds.
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum 1
minute.
Important! In the absence of electricity you
can ignite the burner without electrical device;
in this case approach the burner with a flame,
push the relevant knob down and turn it
counter-clockwise to maximum gas release
position.
If the burner accidentally goes out, turn the
control knob to the off position and try to
light the burner again after minimum 1 minute.
Description
ignition position / maxi-
mum gas supply
minimum gas supply
A
B
C
www.zanussi.com
Advertisement
Table of Contents
