LG-Nortel LSP-450 User Manual page 4

STEP I. Check Components
▶The following components are supplied Fixed
Wireless Phone.
. LSP-450 Main Phone with Handset
(Including inner backup battery) -EA-
. Dipole Antenna-
3. AC/DC Power Adapte
4. User Guide
▶Please make sure that these components are
present before youbegin to install the phone. If any
of the components are missing or damaged,contact
your service provider immediately.
STEP II. Place the Terminal
▶Place the phone on the stable flat surface area
(desk, table, etc).Serious damage may result if the
phone is dropped. Do not placethe phone within
 meter of heaters or radiators.
▶This phone is designed for desktop usage. Avoid
the directexposure to sunlight and dampness.
▶Read the SAFETY INFORMATION located in the
first part of thisdocument before you lace the phone.
STEP III. Connect Components
(Please refer to "Installation Steps" in 1.4)
▶Connect the antenna to the TNC antenna connector
located atthe top of the phone.
▶If you have placed the phone on a flat surface,
-EA-
position theantenna upright.
-EA-
▶Connect the curl cord of the handset to the RJ-
-EA-
port locatedon the left side of the phone.
▶Connect the AC/DC Adapter cable to the DC input
port locatedat the top of the phone.
- If it is correct, a beep tone will be heard.
- If it is not correct (Booting fails or beep tone is not
heard), you willhave to reconnect the adapter or
reset the battery.
▶Please observe the following to get better voice
quality.
. Keep away from electrical appliances such as TV,
computer, radioetc.
. Keep the phone in a high and central location
without anyobstructions.
3. Raise the integral antenna of the phone to get
maximum strengthas shown in the figure.
Introduction
3