Makita DHR400 Instruction Manual page 12

Connecting the tool to the vacuum
cleaner
Attach the holder joint to the tool, and then attach
1.
the hose holder to the holder joint.
► 1 . Holder joint 2. Hose holder
Fix the hose to the hose holder.
2.
► 1 . Hose holder
NOTE: Use joint 25 to connect the hose and the dust
cover if necessary.
Using depth gauge for drilling
operation
When you stack two bellows, attach the depth gauge
extension to the depth gauge.
1
1
► 1 . Depth gauge extension
Dust extractor attachment (for
hammering only)
2
Optional accessory
1. Install the hose holder.
When the side handle is installed to tool, loosen the
clamp nut, and then remove the hex bolt. Install the
hose holder with the hex bolt and the clamp nut by
tightening the clamp nut firmly.
1
► 1 . Bolt 2. Hose holder 3. Clamp nut
When the side grip is installed to the tool, loosen the
side grip, mount the hose holder to the shaft, and then
tighten the side grip firmly.
12 ENGLISH
1
2
3