Mounting Options
Figure 9. Installing the Vehicle Dock Assembly on the Mount
Inserting/Removing the 4400
Inserting the 4400 in the Dock
To insert a 4400 terminal into the Powered Vehicle Dock, perform the follow-
ing steps:
14
Ram Ball
Ram Ball
Assembly
2. Loosen the Adjustment Knob slightly to tilt the Vehicle Dock to the
desired mounting angle. Re-tighten the Adjustment Knob securely.
3. Route and connect all cables (see "Power and Peripheral Device Connec-
tions" starting on page 19 for more on connections). If you haven't
already prepared the power connection, reference "Electrical Consider-
ations" starting on page 5 for wiring information.
1. Slide the Falcon up under the top of the Powered Vehicle Dock.
2. Push upwards to lift the spring-loaded top to allow insertion of the Fal-
con as shown in Figure 10 on page 15.
®
Falcon
4400 Series Powered Vehicle Dock
Adjustment
Knob