Remote Controller; Preparation; Basic Operations For Rc-Dv340 (Supplied) - Kenwood DDX795 Instruction Manual

Monitor with receiver
Table of Contents

Advertisement

Remote Controller

Remote Controller
• For DDX6018BT/DMX6018BT/DDX5018BT/
DDX718WBTL/DMX718WBTL: This unit can be
operated using the remote controller (RC-DV340)
supplied with this unit.
• For DDX795/DDX775BH/DDX595/DDX575BT:
Optional remote controller KNA-RCDV331 is
designed for controlling this unit. Refer to the
instruction manual that comes with the remote
controller.
CAUTION
• Put the remote controller in a place where it will
not move during braking or other operations. A
dangerous situation could result if the remote
controller falls down and gets wedged under the
pedals while driving.
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat
generation may result.
• Do not recharge, short, break up or heat the battery,
or place it in an open fire. Such actions may cause
the battery to leak fluid. If spilled fluid comes in
contact with your eyes or clothing, immediately rinse
with water and consult a physician.
• Place the battery out of reach of children. In the
unlikely event that a child swallows the battery,
immediately consult a physician.
56
ENGLISH

Preparation

Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
• Always insert batteries from – poles to avoid bending
the springs.
• If the remote controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace
both batteries with new ones.
Remote controller mode switch
The functions operated from the remote controller
differ depending on the position of the mode switch.
AUD
DVD
T V
• AUD mode: Switch to this mode when controlling a
selected source or tuner source, etc.
– When controlling a player that is not integrated in
the unit, select "AUD" mode.
• DVD mode: Switch to this mode when playing DVDs
or CDs etc. with the player integrated in this unit.
• TV mode: Not used.
• NAV mode: Not used.
• The position of the remote control mode switch is
indicated in the title of each mode, e.g., "AUD mode".

Basic operations for RC-DV340 (supplied)

AUD
DVD
T V
NAV

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents