Dolmar GE-4300 L Instruction Manual page 11

(e) After 20 to 30 seconds of warm-up is completed,
turn the engine switch to "
(See Fig. 3-e)
q "
" (CHOKE)
(f) Make sure the pilot lamp is on.
This indicates that the generator is properly
operating.
2. USING ELECTRIC POWER
Make sure that the appliance is switched OFF before connecting it to the generator.
■ ■
Do not move the generator while it is running.
■ ■
Be sure to ground the generator if the connected appliance is grounded. Failure to
■ ■
ground unit may lead to electrical shock.
(1) CONTROL PANEL
q PILOT LAMP
w AC CIRCUIT BREAKER
e AC RECEPTACLES
(2) AC APPLICATION
(a) Make sure the pilot lamp is turned on.
(b) Turn off the switch(es) of the electrical
appliance(s) before connecting to the
generator.
(c) Insert the plug(s) of the electrical appliance(s)
into the receptacle.
(d) Turn on the switch of the appliance.
" (OPEN) position.
w "
" (OPEN)
WARNING
1 2
5
NOTE
If the pilot lamp is off, Set the AC breaker
■ ■
to "ON" position.
If no generating condition is found out,
■ ■
please consult nearest DOLMAR factory
or authorized service center.
3
4
r GROUND TERMINAL
t ENGINE SWITCH
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
GB
7