Replacing The Display Assembly; Procedure; Post-Requisites - Dell Inspiron 11 3000 Service Manual

Replacing the display assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display back-cover and antenna assembly.
1 Place the display assembly on a flat and clean surface.
2 Align the screw holes on the display hinges with the screw holes on the palm-
rest and keyboard assembly.
3 Replace the two screws (M2.5x6) that secure the display assembly to the palm-
rest and keyboard assembly.
4 Slide the display cable into the connector on the system board and close the
latch to secure the cable.
5 Slide the display-cable bracket into the slot on the palm-rest and keyboard
assembly.
6 Align the screw hole on the display-cable bracket with the screw hole on the
system board.
7 Replace the screw (M2x3) that secures the display-cable bracket to the system
board.

Post-requisites

1 Replace the wireless
2 Follow the step 4 procedure in
3 Replace the battery.
4 Follow the procedure from step 2 to step 5 in
computer. After working inside your computer, follow
After working inside your
card.
"Replacing the I/O
computer. For more safety best
www.dell.com/
board".
"Replacing the base
Before
cover".
63