Resetting To Factory Defaults; Restarting The Stm150 - NETGEAR STM150 Reference Manual

ProSecure Web/Email Threat Manager STM150 Reference Manual

Resetting to Factory Defaults

Warning: If you reset the unit, all configuration settings will be lost, the default
password will be restored, and you will need to re-register the product license.
You can use the default button on the Backup & Restore Settings page to revert to factory default
settings, or you can use the reset button on the back of the unit.
Reset button
Figure 3-9
Use the Reset button to restore the factory defaults. Use a sharp object, press and hold this button
for about ten seconds until the front panel Test light flashes to reset the unit to factory default
settings.

Restarting the STM150

Restarting the STM150 will temporarily terminate all network connections that pass through the
STM150. Network connection is restored as soon as the restart and startup processes are
completed, usually within a minute or two.
Restart button
Figure 3-10 New Photo
On the rear panel, press the Restart button: this restarts the unit; it does not reset the appliance to
its factory defaults.
Performing System Management Tasks 3-13
v1.0, January 2009