Displayport Ver; Hdmi Mode; Source Detection; Key Repeat Time - Samsung C49HG90DM Series User Manual

DisplayPort Ver.

Select your DisplayPort version.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI1, HDMI2,
DisplayPort
message Check Signal Cable or power saving mode activates, press the JOG button to display the function-
button screen and then select the button to display the On Screen Display (OSD). You can select 1.1,
1.2↑.
― If setting the
DisplayPort Ver. to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the display cards cannot achieve the level of 120 Hz/144 Hz.
― If you select 1.2↑, the monitor can support up to 3840 x 1080 @ 144 Hz and 10-bit color input signals.

HDMI Mode

Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode to 1.4, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
― Set the
HDMI Mode to 1.4 when there is no sound output from the DVD connected to our product.
― This menu is not available when
PBP is enabled.

Source Detection

Select either Auto or Manual as the method to recognize input signal.
or MiniDP) is in power saving mode or is displaying the

Key Repeat Time

Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If
when a button is pressed.
1.2 or

Power LED On

Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.

Reset All

Return all the settings for the product to the default factory settings.
―
Game Setting 1, Game Setting
No Repeat is selected, a command responds only once
2, and Game Setting 3 saved under Save Settings will not be changed.
41