Flow Chart To Program The Drive To Display Custom Units "012.0 - KB Electronics KBDA-24D Installation And Operation Manual

FIGURE 21 – FLOW CHART TO PROGRAM THE DRIVE TO DISPLAY CUSTOM UNITS "012.0"
POWER ON
Set Frequency Flashes
("FWD", "STOP", "Hz" LEDs On)
Display Mode
Function No.
Digit Flashes
Display Mode
Custom Units Code
Digit Flashes
Press Up Key 1 Time
to Increase Digit
Press Shift Key 1 Time
to Move Digit
"End" Momentarily Displays
which Confirms Programming
Press Read Key
to Read
Custom Units Display Code
Press Enter Key
to Save New Code
Press Display Key
to Change Display
28
Press Program Key
to Display
Function No.
Press Read Key
to Read
Display Mode Code
Press Enter Key
to Save New Code
Custom Units
Code No.
Digit Flashes
Custom Units
Digit Flashes
Custom Units
Code No.
Digit Flashes
Custom Units Display
3
Whole Numbers Code
Digit Flashes
"End" Momentarily Displays
which Confirms Programming
4
Custom Units Value Flashes
("001.0" = 5 Hz
("FWD", "STOP" LEDs On)
Group No.
Digit Flashes
("PGM" LED On)
Display Mode
1
Frequency Code
Digit Flashes
"End" Momentarily Displays
which Confirms Programming
Press Read Key
to Read
Custom Units Value Setting
Press Up Key 2 Times
to Increase Digit
Press Up Key 1 Time
to Increase Digit
Press Up Key 1 Time
to Increase Digit
Custom Units Display
Function No.
Digit Flashes
Notes: 1. The factory setting of Display Mode (Function
No. 4.00) is Frequency ("0000"). 2. The factory setting
of Custom Units Significant Digits (Function No. 4.01) is
"0100". 3. The factory setting of Custom Units Display
(Function No. 4.02) is Whole Numbers ("0000"). 4. The
Custom Unit setting "012.0" will be displayed at full
speed.
Press Up Key 4 Times
to Increase Digit
Press Up Key 2 Times
to Increase Digit
Display Mode
Code No.
Digit Flashes
2
Custom Units
Digit Flashes
Custom Units
Digit Flashes
Custom Units Display
Code No.
Digit Flashes
Custom Units Display
One Decimal Place Code
Digit Flashes