Cancelling A Programme; Opening The Door - Zanussi ZWF 81460W User Manual

Hide thumbs Also See for ZWF 81460W:
Table of Contents

Advertisement

To cancel the delay start:
1. Touch the button
to pause.
2. Touch the button Delay Start
indicator of the set delay goes off.
Touch the button
programme immediately.
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch
.
The indicator of this button flashes.
2. Change the options.
3. Touch
again.
The programme continues.

Cancelling a programme

1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water.
In this case, make sure that the
detergent is still in the detergent
compartment, if not fill the detergent
again.

Opening the door

While a programme or the delay start operates,
the appliance door is locked. The indicator
is on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the door.
To open the door during the first minutes
of the cycle or when the delay start
operates:
1. Touch the button
appliance.
2. Wait until the indicator
3. You can open the door.
12
to set the appliance
until the
again to start the
for some seconds to
to pause the
goes off.
4. Close the door and touch the button
again. The programme (or the delay start)
continues.
At the end of the programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• The indicator of the button
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent drawer
ajar, to prevent the mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator
drain the water.
• The door lock indicator
indicator of button
stays locked.
• You must drain the water to open the door.
Draining the water:
1. To drain the water.
• Touch the button
drains the water and spins with the
maximum spin speed for selected
washing programme.
• Alternatively, touch the button
change the spin speed and then touch
the button
water and spins. If you set
appliance only drains.
2. When the programme is completed and the
door lock indicator
open the door.
3. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
goes off.
goes off.
for some seconds to
flashes to remind you to
is on. The
flashes. The door
. The appliance
to
. The appliance drains the
, the
goes off, you can
for some seconds to
www.zanussi.com

Advertisement

Table of Contents
loading

Table of Contents