Table of Contents
Advertisement
Problem
The appliance fills with water
and drain immediately.
The washing results are not
satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of
interruption.
If the problem occurs again, contact the
Authorised Service Centre.
If the appliance shows other alarm codes (the
indicator of button
Deactivate and activate the appliance. If the
problem continues, contact the Authorised
Service Centre.
Technical Data
Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where the
low voltage equipment has no protection against moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
www.zanussi.com
•
Make sure that the drain hose is in the correct position. The end of
the hose may be too low. Refer to 'Installation instruction'.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you wash
the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Make sure that you press only the wanted touch button(s).
flashes in red).
Width/ Height/ Depth/ Total
depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
Possible solution
Service
We recommend the use of original spare parts.
When contacting the Authorised Service
Centre, make sure that these data are available.
You can find the information on the rating plate:
model, PNC and Serial Number. (Mod., Prod.
No., Ser. No.)
600 mm/ 850 mm/ 520 mm/ 576 mm
220 - 240 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
A+++
1400 rpm
17
Advertisement
Table of Contents
