Advertisement
Operator's Manual
disconnected. See the Flooding Repair Procedure
for more information.
Integration Procedure
Integrating Instruction
1. Prepare a power supply with 10-36 VDC output.
2. Connect the camera power, HD-SDI video,
analog video, and control signals to their
respective interfaces per the pinout specified for
the camera.
3. Prepare the camera bulkhead connector as
required, verifying proper lubrication of all O-rings
and seal surfaces with a silcone lubricant (spray
recommended).
4. Mate the female underwater connector to the
male bulkhead using a smooth linear motion,
making sure the connectors are fully seated and
seals are engaged.
5. Screw the locking sleeves together firmly (hand
tight-do not use tools). The camera is now ready
for operation; switch the power supply ON to
power the camera. The camera draws a max of
9W during operation and will work when supplied
with 10-36 VDC.
Video Output
The digital HD video output from the camera is a
SMPTE 292M compliant uncompressed HD-SDI data
stream at 1.485 Gb/s. This camera is available with
field selectable 1080p/30, 1080p/29.97, 1080p/25,
1080i/59.94, 1080i/50, 1080i/60, and 1080i/30 image
formats.
Flooding Repair Procedure
If the camera stops working while underwater, you
should assume that it has been flooded. When working
on a potentially flooded camera, it is important to use
appropriate personal protective equipment to include, at
a minimum, eye and hand protection.
1. Immediately turn off the power to the unit.
2. Open the housing by removing the rear end
cap-retaining ring. Grasp the rear end cap in one
hand and the camera housing in the other. With
care, separate the two components using a linear
motion. If required, gently twist components while
separating.
3. Pour out any water trapped in the housing.
4. If the camera is completely flooded, rinse the
HD Zoom SeaCam
internal components with clean fresh water in
order to minimize contamination and corrosion.
5. Allow parts to dry in air or a convection oven set
at 60° C (190° F).
IMPORTANT! DeepSea Power & Light cannot
be responsible for any damage incurred during
emergency field repairs. Such repairs should be
undertaken only as a last resort and by qualified
personnel.
Troubleshooting
1. If the camera stops working while underwater
assume that it has been flooded. See Flooding
Repair procedure.
2. Once it has been determined that the camera is
not flooded, or if it does not turn on during pre-
deployment checks, troubleshoot in the following
sequence:
a. Check the cable/inline connector to make
sure that correct voltage and current
are being supplied, and that the correct
sockets are being used. See page 2 of this
manual for electrical specs.
b. Remove the connector. Inspect the
assembly for visual signs of wear. Use a
multi-meter check for continuity or shorts
in the connector. Try a spare connector, if
available.
c. Check the wires that go from the power
supply to the camera base for wear. If they
appear worn, replace them.
d. If the camera still does not work, return it to
DSPL using the RMA Procedure.
RMA Procedure for Repair
For warranty and non-warranty repairs, please contact
DeepSea Power & Light for an RMA number prior to
returning the item. Please have the model number, serial
number, and any other pertinent information along with
a description of the problem on hand when calling, or
include them in a fax or e-mail.
When shipping the item, be sure that the freight is pre-
paid (CODs will not be accepted) and that the RMA
number is clearly printed on the outside of the box.
®
5
Advertisement
