Table of Contents
Advertisement
Chapter 4
Error Message
Cause
You tried to access a Tel-Index
Not
number that is not programmed.
Registered
The cordless handset is too far from
Searching for
the machine (base unit).
Base Unit
The machine (base unit) is turned
(Base Unit not
off.
detected)
(Optional cordless handset only)
You have not registered the
cordless handset.
Routine maintenance
Charging the battery
If your battery is getting low, you should
charge the battery. You can see the battery
strength at the bottom right of the LCD.
a
Plug the cradle into the AC power outlet.
b
Place the cordless handset in the cradle
with the dial pad facing forward.
(MFC-845CW)
Cleaning
Clean the outside of the cordless handset.
You should also clean the charger charge
contacts. If the charger contacts are not
clean, the battery may not be charged.
21
Action
-
Set up the Tel
Index number. (See Storing
numbers for easy dialing on page 9.)
Bring the cordless handset closer to the machine
(base unit).
Make sure the machine (base unit) is turned on.
Register the cordless handset. (See Registering
additional cordless handsets on page 3.)
CAUTION
4
Use neutral detergents. Cleaning with
volatile liquids such as thinner or benzine
4
will damage the outside surface of the
cordless handset.
DO NOT use cleaning materials that
contain ammonia.
DO NOT use isopropyl alcohol to remove
dirt from the control panel. It may crack the
panel.
Clean the charger contacts as follows:
a
Unplug the cradle from the AC power
outlet.
b
Clean the charger contacts (1) for both
the cordless handset and the cradle with
a cotton swab.
1
4
4
Advertisement
Table of Contents
