JVC KD-G326 Instructions Manual page 11

Indications
WOOFER 2
*
Subwoofer cutoff
frequency
L/O MODE
Line output mode
TAG DISP
Tag display
AMP GAIN
Amplifier gain
control
2
* Displayed only when "L/O MODE" is set to "WOOFER."
Selectable settings, [reference page]
LOW :
Frequencies lower than 55 Hz are sent to the subwoofer.
MID :
[Initial]; Frequencies lower than 85 Hz are sent to the
subwoofer.
HIGH :
Frequencies lower than 115 Hz are sent to the subwoofer.
When connecting an amplifier or a subwoofer, set this correctly.
REAR : [Initial]; Select if the REAR LINE OUT terminals are used
for connecting the speakers through an external amplifier.
WOOFER : Select if the REAR LINE OUT terminals are used for
connecting a subwoofer.
TAG ON :
[Initial]; Shows the ID3 tag while playing MP3/WMA tracks,
[8].
TAG OFF :
Cancels.
You can change the maximum volume level of this unit.
LOW PWR : VOL 00 – VOL 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid damaging the speaker.)
HIGH PWR : [Initial]; VOL 00 – VOL 50
11