Using Hyperterminal W/Rs232 - Barnstead SUPER-NUOVA HP133420-33 Operation Manual And Parts List

Using HyperTerminal w/RS232

With HyperTerminal you can store the RS232 output data
of a SUPER-NUOVA on a PC. NOTE: Other terminal
programs that capture RS232 data can be used as well.
In order to follow this procedure, you must have:
• Microsoft Windows 95‚ or greater with
HyperTerminal installed (it is available from the
Windows installation CD if not installed already).
• A PC that has an available 9 pin DB-9 RS232
connector.
• WHX18 (Accessory) – PC to hot plate communi-
cations cable – Connect it from the back of the
hot plate to the communications port desired.
To Setup HyperTerminal:
1. From the START menu of Windows‚ select
ACCESSORIES, COMMUNICATIONS, HYPER-
TERMINAL
2. Type in a name (example: SuperNuova) that
you would like to refer to the connection by in
the NAME box. You may also select an icon if
you would like. Then select OK.
3. Select the RS232 port that you plan to use to
connect to the hot plate (typically Com 1 or Com
2). Then select OK.
4. Under port settings, select the following:
• BITS PER SECOND: 57,600
• DATA BITS: 8
• PARITY: NONE
• STOP BITS: 1
• FLOW CONTROL: NONE
Then Select OK.
O
PERATION
19