Spectrum 802.11ac Wave 2 User Manual page 87

2.4.3.2.2 Net Service Filter
Net Service Filter can work in either White List or Black List mode. When running in White
List mode, it only lets certain packets get through the WiFi Router. While in Black List mode,
it only blocks certain packets passthrough.
Steps to set Net Service Filter:
1. From the navigation panel, go to Advanced> Security> IPv4 Firewall> Net Service Filter.
2. Enable Net Service Filter:
3. Filter Table List:
4. Filtered ICMP packet types: This field defines a list of LAN to WAN ICMP packets type
5. Source IP: For source or destination IP address, you can:
(a) enter a specific IP address such as "192.168.122.1";
(b) enter IP addresses within one subnet or within the same IP pool such as "192.168.123.*"
or "192.168.*.*";
(c) enter all IP addresses as "*.*.*.*".
Enable or disable this module.
There are two kinds of filter list: White List, Black List. White
List can make WiFi Router serve the specified service defined
in the list, Black List make WiFi Router deny serving the
specified service.
that will be filtered. For example, if you would like to filter
Echo (type 8) and Echo Reply (type 0) ICMP packets, you
need to enter a string with numbers separated by blank, such
as [0 8].
86