Advertisement
Exception Modes
In case of a DMX signal loss or over-temperature condition, the luminaire will respond
as follows:
Condition
Valid DMX signal
DMX
is lost while in
Fails
DMX mode
Over
Unit exceeds
Temp
temperature limit
RDM
The Bullet Luminaire supports basic RDM functionality per ANSI E1.20 (RDM-Remote
Device Management over USITT DMX512 Networks) specification.
Focusing the Beam
To focus the luminaire, loosen the Focus Lock knob and rotate the front of the barrel to
adjust the position of the lens. The more the barrel is extended, the more narrow the
beam.
Bullet Series 2.0 LED Luminaire Quick Start Guide
Version as of: September 14, 2015
PRG document number: 02.9832.0002
©2015 Production Resource Group, LLC.
Response
Luminaire will hold last "look" and resume DMX com-
mands when valid DMX data is received again. (Also see
Blink function of the
NOTE: Look will not hold through power loss.
Output power is disabled until power is cycled or temper-
ature falls below threshold. (Also see Rapid Blink function
of the
LED
Indicators.)
Focus Lock
Figure 7: Focus Lock Knob
LED
Indicators.)
539 Temple Hill Road
New Windsor, NY 12553-5533
Advertisement
